ASME GD&T – Pattern vs. ISO GPS – Combined zone
ASME GD&T – Pattern vs. ISO GPS – Combined zone-New GD&TIP: The two standards have opposite defaults GD&T 2X Qualifies a Group as a Pattern,
Menu
ASME GD&T – Pattern vs. ISO GPS – Combined zone-New GD&TIP: The two standards have opposite defaults GD&T 2X Qualifies a Group as a Pattern,
General Tolerance on a drawing establishes a default tolerance, thus saving repetitive annotations on the drawing. Previous Tip (General Tolerance) demonstrated Plus / Minus Dimensions
(ASME Y14.5-2009, ISO 1101:2012) Orientation deviation is controlled and measured against a Datum Reference Frame, or in short – DRF. The datums and the reading
(ASME Y14.5-2009, ISO 1101:2012) Our monthly tip, following Idan’s question on how to indicate symmetry. In Figure 1, the two threads on the front are
(ASME Y14.5-2009, ISO 1101:2012) Our monthly tip following Benny’s suggestion – how do datums affect the control of position with regards to groups of holes?
Are geometric tolerances only applicable for machining? (ASME Y14.5-2009, ISO 1101:2012) This tip’s frame story is a fable, but the lessons learned are real. The
What is the difference in meaning, if any, between the different forms of notation? (This tip complies with ASME Y14.5-2009 and ISO 5459:2011) Datums Reading
(This tip is compliant with ASME; for ISO it is necessary to add E to the dimensions of the wave diameter in Figure 1, a
Please contact:
Info@TES-tec.net
+972 74 704 7060
or
To learn more about
upcoming On-Line/Frontal GD&T training Seminars
Please contact
Info@TES-tec.net
60 74-704-70 (972)+
or
Fill out the form